DESCRIPTION
Anderson Composites VIP carbon fiber parts are manufactured by spraying a coat of resin on the mold, sheets of carbon fiber fabric are laid out across the mold and then a final coat of resin is applied on the fabric before being placed inside a vacuum sealed bag to cure (provides an excellent fabric-to-resin ratio). Once cured, the part is removed from the mold, trimmed and a final coat of gel coat applied and polished to protect the surface and increase the high luster finish. No additional clear coat is required.
FEATURES
- Fiberglass "skeleton" bonded to underside of carbon fiber hood for strength and support
- Does not include hood vent
- Mounts with OE hardware
- Vacuum infused process with 3K, 2x2 twill carbon fiber cloth, gloss finish
- Hood only, center section sold separately (P/N AC-HDS14CHCAM-Z28)
- Hood pins required for safety reasons - AeroCatch or Quic-Latch
- Heat shield required
- Anderson Composites does not suggest re-installing gas shocks/dampers/struts
- The use of a hood prop rod is highly recommended
- Hoods are hand crafted and weigh approximately 21.0 lbs.
SHIPPING NOTE:
Anderson Composites packs all products carefully to prevent damage during shipping. However, damage may still occur occasionally. Buyer must inspect the packaging and the products carefully upon receiving them, then accept the shipment and notate any damages and irregularities, such as crushed, torn, punctured, or broken parts on both the packaging and the product, on the freight bill or receipt at the drivers presence. Buyer must retain all cartons, packing materials, and damaged products for the carriers damage inspector to inspect. Do not refuse shipment or return it without approval, because the buyers right to make a damage claim may be denied. A signed receipt without any notation indemnified the carrier as well as Anderson Composites from any further damage claims. Discovery of damages after a clear delivery becomes the responsibility of the customer.
